BSL Box V9.3 is a CombiLoader adapter for Bosch EDC16 BSM (J2534) and Bosch MEDC17 BSM (J2534) modules as well as other modules that work in BSL or on the bench.

Connecting:

Сonnect the Scanmatik 2 PRO, Tactrix Openport 2.0 adapter via OBD II to BSL Box V9.3

5.5*2.1 12V/3A connector is used for the power supply connection, with the protection against polarity reversal and current overload turned on.

The connection to the ECU is done via DB15 or DB25 with the use of the universal or specialised cable. Simultaneous connection of 2 universal or specialised cables is also possible.

The BSL Box V9.3 adapter allows changing the power supply connected to the 30 and 15 terminals manually. The switches on the right side are the following:

the top one turns on the automatic power control (L–Line)

the bottom activates Boot Pin, the manual power control, the automatic control is on by default (12 pin OBD2)

The LED indicators indicate the presence of the voltage supply for terminals 15 and 30, as well as Boot pin activation.

BSL Box V9.5 Adapter displays the status of K-Line, L–Line and CAN signal lines with LED indicators (which is very convenient). There also is a 120 Ohm terminating resistor installed for CAN.

The pins to connect to the ECU

DB25:

1. K-Line

2. GPT1(Scanmatik 2/PCMflash)

4. GPT2(Scanmatik 2/PCMflash)

5. +12 after IGN (K15)

17. +12V (K30)

19. 19. CAN-L 14 pin OBD2

20. 20. CAN-H 6 pin OBD2

22. GND

DB15:

1. Boot 1 (1kOhm)

2. VPP

3. GPT2(Scanmatik 2/PCMflash)

4. CNF (1kOhm)

5. +12 (K30)

7. CAN-H

9. +12 after IGN (K15)

10. Boot 2 (1kOhm)

11. GND

12. GPT1(Scanmatik 2/PCMflash)

14. K-Line

15. CAN-L