All OBD and Bench protocols for ECUs are rounded up in this module. This module can use FLX2.10 or FLX2.11 cables (general purpose OBD and ENET cable). An increased programming speed compared to X17. Stability of protocol is even higher, which allows for safer writings even in less expensive working environments. In case of Master & Slave ECUs, Flex will automatically recognize the Slave ECU and write the same file loaded to the Master ECU to both – now there will be no reason to worry about remembering to write both ECUs manually!

The Flex TCU SW Package allow full read and full write of the TCU, including each of the memories stored inside the transmission control unit without any encryption. It just doesn’t require to open the control unit, while allowing exactly the same functions as a regular boot mode. Tuning, align, bypassing security and restoring backup are no issue at all. The different is the fact that files are non encrypted and that the speed has been generally been improved.

Furthermore, you do not need to make any ignition switch, as Flexbox will take care of it. Reading times have been tested from 2 to 3 minutes in total, depending on ECU model. Writing times depend on actual size of modification inside file, from few seconds to about 9 minutes.

The Flex BDM MPC5XX SW Package allows full read and full write of the ECU, including each of the memories stored inside the control unit without any encryption. In case of master and slave ECUs, both are supported.

This protocol is way faster than any other BDM tool on the market, especially since it has been designed for a fairly new hardware. Tuning, pairing and restoring backup are no issue at all, and can be done in few seconds. It will also be possible to read and write the shadow memories (content will be added to internal flash read), which comes useful when dealing with BMW ECUs.

Reading times have been tested around a minute in total, depending on the ECU model. Writing times do not depend on actual size of modification inside the file, as the tool is fast enough even without skipping sectors. Less than two minutes will be more than enough for a complete clone. If you are a previous owner of MAGP1.16 BDM MPC5xx plugin, this new protocol is totally free of charge. Also owners of previous BDM tools (MAGP1.11 and MAGP1.14) will receive it for free.

Full package of software functions for FLEX in Slave version

COMPLETE BENCH MEDC17 SOFTWARE  PACKAGE  FOR PROGRAMMING 

BOSCH MEDC17 ECUS DIRECTLY FROM THE ENGINE CONTROL UNIT CONNECTOR

FLEX SW PACKAGE DEDICATED ENTIRELY TO CONTROL UNITS FOR 

MOTORCYCLES

SW FLEX ECU (CARS,VANS,BIKES) OBD+BENCH SLAVE

SW FLEX NEXUS MPC5XXX SLAVE

SW FLEX RENESAS SH7XXXX SLAVE

SW FLEX ST10F2XX SLAVE

SW FLEX NEC 76F00XX SLAVE

SUBSCRIPTION FEE FOR FLEX OBD MASTER -12 MONTH RENEWAL